chicken ship

remote controlled boat, 22 and a half inches long

stringers

water cooling exit out of exhaust

Amazon/offshore electronics, 

 -3m hardware kit   

  -optional 12-20$ water pump 2x,     

-30-32mm props

 -4mm stainless steel shafts 

-brass stuffing tubes for 4mm stainless steel shafts

-12mm neodymium magnets (i used 3)

-epoxy for bottom of hull and 4200 or a sealant for thru holes

-grease i left room to grease struts as well so you can dry test safely 

boat building experience recommended, you want to have as much weight in the back as you can as the flair is heavy, can print in pla and add epoxy to bottom or the whole water line, 4200 is the best sealant for shaft thru holes or thru holes out of exhaust for water cooling. i recommended a bilge pump i keep mine on when running, sometimes turning hard throws some water in the hull. transom is kind of tight under the deck I fit my 2 batteries still under the deck in between transom. comes with motor mounts you can try out. canopy cage was kind of hard to print i included cut up pieces and the full version. cut up pieces do not include front supports for canopy so be sure to open "full canopy" for front supports if you print cut up version.

amazon bilge pump is like 12$, I included mount in the files, and everything on my site uses 3m hardware buy a 20$ amazon kit, it should last you a handful of projects, I have a trailer for the boat however even with tri axles the wheels struggle to stay on rim, I'll have the trailer for sale but don't know if it will be for the boat yet as I'm not satisfied with the results yet. with twin screw boats you want the shafts and props to spin opposite direction so one clockwise the other counterclockwise. you would want a clockwise and a counterclockwise spinning prop. I would not print the front hull piece at 100%infill because the flair will weigh too much. my print sits a little bow heavy but with any throttle at all rides realistic and looks beautiful. 

I assume if you want to add trim tabs for more speed they need to be installed flat based off my experience with real boats 

I have bamboo p1s, although I included full hull in files as well for anyone with big printers.

I have had 0 help or training I work on these boats in real life everything is originally my design and work, no tracing involved, this boat was made in 2024.

always email me with any suggestions or questions i will help from beginning to end as this is all I care about. 

-thank you!